A: the product:
High riser of lamps and lanterns is according to GB7000.1-2002 GB/T15497 - safety requirements and experiment of lamps and lanterns 1995 enterprise standard system constitution and the requirements of technical standard system and appliance switch GB15092.1-2000 in the first part: the general requirements of the requirements, the development and production of a new generation of apply to the replacement of light source of lamps and lanterns, repair electrical mechanical and electrical integration of the lamps and lanterns is lifting gear.。
1;Use this device to a higher position of the surface of the lamps and lanterns to work, to replace or repair electrical appliances, after the completion of the lamps and lanterns again automatically to the original height, make its recovery in situ.This device adopts the remote control to lift control of lamps and lanterns, this device is suitable the place: tall, factory workshop, warehouse, sports hall, supermarket, logistics center, aircraft hangars, aircraft maintenance factory building, exhibition hall and so on.
1. The rated supply voltage: 220 v + / - 10%
: 2. The rated frequency 50 hz
3. The rated working current: 10 kg in weight lifting gear load, working current of 0.7 or less A
Lifting gear load weight 15 kg, the working current of 0.8 or less A
4. Lifting: at an average rate of average rate rise: 0.05 M/S or less
Falling average speed: 0.06 M/S or less
5. Lifting height: 20 m (in this batch of products)
Three: introduction of structure
1. High conductive parts of the lamps and lanterns with advanced lighting power supply by the conductive column and the conductive ring close pressure (pressure of 2 kg/m ㎡) state of conduction.Conductive rate was 100%.When the state of separation between the two, lamps and lanterns is in a state without electricity, after finish the homework to in situ, the automatic pressure.
2. The fixed and positioning of lamps and lanterns
In situ, lamps and lanterns to guide rod part of the device accurately and automatically into the device guide hole parts, realizes the fixed and positioning, in order to prevent the motion of the lamps and lanterns in the high position, make the lamps and lanterns in the stationary state.
3 high levelers lifting weight series of lamps and lanterns: lifting gear load weight 30 kg; 8 kg, 15 kg,Lift high
4. Lamps and lanterns levelers collision avoidance and high security.
High levelers will rise to the original position of lamps and lanterns of lamps and lanterns, by travel switch components, the control circuit power supply will be automatically cut off, conduction lighting power supply automatically.
5. High control part of the lamps and lanterns levelers
Lamps and lanterns of high elevator control part is: wireless remote control
4: high elevator installation of lamps and lanterns:
Installation: type suction a top riser should be installed vertically.
5: high riser of lamps and lanterns and lamps and lanterns of connection form:
1. The threaded connection
2. The flange connection
3. The hook type even
Six: high applicable lamp type lamps and lanterns levelers
Lamps and lanterns of high levelers for all kinds of high pressure die casting aluminum molding electric appliance box and cooperate with high purity aluminum reflector lamps and lanterns.
Seven: packaging requirements
1. This company produces the elevator will have a second packaging form.
The inner packing: plastic bubble
Packing: corrugated carton: a case of one
2. The product specification and are in a box the lamps and lanterns.
3. The outer packing has the company on packaging
8: warning:
1. The top riser installation before no electricity!
2. The circuit power wire connect with advanced wire L terminal, zero line N terminal, levelers all wire must be in phase;Elevator control system shall be independent!
3. The elevator must be installed vertically.